Skip to content

One rep max calculator.

Your one rep max is the most weight you can lift once with good form. You can estimate it without lifting that much: enter a weight and the clean reps you did with it, up to 10. The calculator uses the Brzycki equation, which one study found the most valid for the bench press at 10 reps or fewer.

One rep max
Units
From 1 to 10. Count only the reps before your form broke.

Enter a weight and your clean reps to estimate.

Worked out on your device. Nothing is sent or stored.

Your one rep max, from a lighter set.

Enter a weight you lifted and the clean reps you did with it, from 1 to 10. You will see your estimated one rep max, and the weights at a few percentages of it.

Health note. This page is general information to help you exercise, not medical advice, and the result is not a diagnosis. Ask your doctor before you start if you have a heart condition, get chest pain, dizziness or breathlessness when you exercise, or have been told to limit exercise. Stop if anything hurts or you feel unwell.

How it works

The formula, in plain words.

The more reps you can do with a weight, the further that weight is from your maximum. The Brzycki equation turns that into a number: it divides the weight by a figure that gets smaller with each rep you did. One rep gives back the weight itself; ten reps raise it by about a third.

It is a published equation, used in research to estimate strength without a maximum lift.

Key facts

Its limits

A guide, not a test result.

  • It is an estimate. Two people with the same set can have different maximums.
  • It stops at 10 reps, the range where the equation was found most valid for the bench press.
  • It counts clean reps only. A rep where your form broke is not a rep.
  • It compares like with like: the same lift, done the same way, is the number to track over the weeks.
How I would use it

A number to train from, not one to chase.

In my method, the weight goes up only when the current weight is steady, and a form break means it comes down, whatever the number says. The estimate helps you choose a working weight and see progress. It is not a target for a heavy single.

If you are new to lifting, start with what strength training is and a weight you control.

Strength is one measure. The Five Minute Baseline adds balance, a squat and your energy: three quick checks at home. Allow five minutes, including the instructions.

Questions

What people ask first

How accurate is a one rep max calculator?

It gives an estimate, not a measurement. The Brzycki equation was the most valid for the bench press when a set was 10 reps or fewer, so this calculator stops at 10. A heavier set of fewer reps is closer to your maximum, so it leaves less to estimate.

Should I test my real one rep max?

Not to start with. A true one rep max test may be unsuitable for people with no previous lifting experience. An estimate from a lighter set shows you where you stand and how you progress, without the heaviest lift of your week.

What counts as a rep?

A full rep with clean form. If the form breaks, the set ends there: count only the reps before it. In my method, a form break means the weight comes down, whatever the number says.

Which lifts can I use it for?

It was studied on lifts such as the bench press. Use it for the big movements you load with a barbell or dumbbells, the same lift done the same way each time, and compare your own estimates over the weeks rather than with anyone else.

Twenty minutes, with me.

We talk about your week, your health and what you have tried before. If the program fits you, I will say so. If it does not, I will say that too.